Pay attention when producing glass bottles and matching caps

Pay attention when producing glass bottles and matching bottle caps. First of all, you should pay attention to preparing more than a dozen matching bottle caps, so that you can always try to make the bottle mouth and bottle cap inconsistent. In the team of the machine, you just use bottle clamps before hitting the oven. Put a few handfuls aside, remember to cool down on the bottle cap, wear gloves, because there is no fire, it will easily explode. Safety first, ensure that the bottle mouth matches and can be produced normally.

Secondly, after the glass bottle is put on the machine, the bottle cap is handed over to the packaging supervisor for them to do the experiment. They had to go to the packing room to do the experiments themselves. Sometimes, the master often oil the glass bottle after it is on the machine, which can easily cause the position of the mold thread on the bottle mouth, and the putty will make the bottle mouth smaller. The cap must be on to try it out.

This is the experience accumulated by our glass bottle factory. I hope all friends in the industry see this and notice this when producing glass bottles, this connection is often wrong, and I hope we have to be responsible to buyers and ourselves.